|
|
Saw Sharpening
Displaying 1 to 12 (of 12 products)
| Product Image |
Item Name+ |
Price |
 |
For big-tooth saws with a pitch of 2 or less teeth per inch e.g. saws over 36 inches long or our other product Peg tooth saw blank 2 points per inch.... |
£14.95
[more]
|
 |
For saws with a pitch of 4 or less teeth per inch. Because the file is single cut it leaves the tooth smooth in contrast to aggressive double cut... |
£9.95
[more]
|
 |
For big-tooth saws with a pitch of 3 or less teeth per inch e.g. saws over 36 inches long or our other product Peg tooth saw blank 2 points per inch.... |
£11.95
[more]
|
 |
Because these rasps are punched by hand every tooth cuts in a slightly different place. The image shows the teeth are not perfectly aligned. They are... |
£29.95
[more]
|
 |
The axe file has a coarse double-cut side and a fine single-cut smooth side. Start with the double-cut coarse side for rapid removal of metal then... |
£17.95
[more]
|
 |
This handle-blank is slotted and ready for insertion of a sawplate. Fixings of 4mm bolts and tee-nuts included. You can quickly shape this to fit... |
£24.95
[more]
|
 |
Put this in a jointer and file off the tops from your saw teeth to bring them all to the same height. This flattens those teeth even slightly taller... |
£10.95
[more]
|
 |
This device keeps the file at right-angles to the saw as you push down on it - and your fingers away from the teeth. It is far safer and more... |
£24.95
[more]
|
 |
|
£19.95
[more]
|
 |
An elegant device usable on ALL saws but especially those under 26 inches. Either clamp it to a horizontal plank or table or fix it vertically in a... |
£58.95
[more]
|
 |
Most commonly used to remove rust-pits from the sides of teeth and also to taper-grind a saw plate. |
£19.95
[more]
|
 |
Place this perfectly flat piece of steel over any 3 teeth. If any are out of joint there will be a gap. Pass a feeler gauge between this plate and a... |
£14.95
[more]
|
Displaying 1 to 12 (of 12 products)
|
|
